|
walter inserts
|
|
06-19-2015, 06:17 PM
I was able to modify one of my 3/8 shank triangle insert holders to use these inserts, I haven't used it a lot but they do a pretty good job of roughing out a part in the lathe, I've taken cuts as deep as .060 with no problems.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
walter inserts - by dallen - 05-23-2015, 01:20 PM
RE: walter inserts - by PixMan - 05-23-2015, 04:07 PM
RE: walter inserts - by dallen - 05-23-2015, 05:00 PM
RE: walter inserts - by PixMan - 05-23-2015, 06:11 PM
RE: walter inserts - by dallen - 05-23-2015, 06:39 PM
RE: walter inserts - by dallen - 05-29-2015, 03:51 PM
RE: walter inserts - by PixMan - 05-29-2015, 03:59 PM
RE: walter inserts - by dallen - 05-29-2015, 04:04 PM
RE: walter inserts - by PixMan - 05-29-2015, 06:11 PM
RE: walter inserts - by dallen - 05-29-2015, 06:24 PM
RE: walter inserts - by PixMan - 05-29-2015, 08:28 PM
RE: walter inserts - by dallen - 05-29-2015, 08:41 PM
RE: walter inserts - by PixMan - 05-29-2015, 10:18 PM
RE: walter inserts - by dallen - 05-30-2015, 06:10 AM
RE: walter inserts - by PixMan - 05-31-2015, 09:45 AM
RE: walter inserts - by dallen - 06-19-2015, 06:17 PM
RE: walter inserts - by PixMan - 06-19-2015, 07:44 PM
|
