Rotary table want to make good decision

Thread Modes

Help Rotary table want to make good decision

Kennyv Offline

Junior

Posts: 258
Threads: 30
Joined: May 2015
Location: NJ

06-12-2015, 09:07 AM

thanks guys for all your help support purchased the 6" Vertex from PM when I received my mill on wed... and thanks to you all have the correct divining plates on order
Mots of the feed back I received was go with the 6" RT for that size mill after setting up mill I have to concur its a good fit for the PM-25MV

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Rotary table want to make good decision - by Kennyv - 06-05-2015, 09:37 AM

RE: Rotary table want to make good decision - by dallen - 06-05-2015, 10:18 AM

RE: Rotary table want to make good decision - by EdK - 06-05-2015, 10:42 AM

RE: Rotary table want to make good decision - by Kennyv - 06-05-2015, 10:49 AM

RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:23 PM

RE: Rotary table want to make good decision - by f350ca - 06-05-2015, 11:42 AM

RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:25 PM

RE: Rotary table want to make good decision - by Vinny - 06-05-2015, 04:11 PM

RE: Rotary table want to make good decision - by Kennyv - 06-12-2015, 09:07 AM

RE: Rotary table want to make good decision - by zmotorsports - 06-12-2015, 09:29 AM

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me