| The following warnings occurred: | ||||||
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
|
|
Grinding tool bits
|
06-26-2015, 01:31 PM
This is probably quite a daft question, but is it possible to grind down a tool bit using a diamond-coated slitting disk rather than a grinder (In a high-speed minidrill)? This is for a very fine groove to be made in a bit, which a grinder won't make very well (Or at least, what we've got!).
Jason |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Grinding tool bits - by RandaB - 06-26-2015, 01:31 PM
RE: Grinding tool bits - by DaveH - 06-26-2015, 02:18 PM
RE: Grinding tool bits - by RandaB - 06-26-2015, 02:45 PM
RE: Grinding tool bits - by dallen - 06-26-2015, 05:24 PM
RE: Grinding tool bits - by DaveH - 06-26-2015, 05:35 PM
RE: Grinding tool bits - by DaveH - 06-26-2015, 05:43 PM
RE: Grinding tool bits - by stevec - 06-26-2015, 05:45 PM
RE: Grinding tool bits - by EdK - 06-26-2015, 08:02 PM
RE: Grinding tool bits - by dallen - 06-26-2015, 05:53 PM
RE: Grinding tool bits - by DaveH - 06-26-2015, 06:05 PM
RE: Grinding tool bits - by stevec - 06-26-2015, 06:06 PM
RE: Grinding tool bits - by Roadracer_Al - 06-26-2015, 11:04 PM
RE: Grinding tool bits - by EdK - 06-27-2015, 12:16 PM
RE: Grinding tool bits - by Roadracer_Al - 06-28-2015, 01:24 PM
|
