MetalworkingFun Forum › Machining › General Metalworking Discussion v
Slitting saw problem

Thread Modes
Slitting saw problem
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
The following 1 user Likes Roadracer_Al's post:
Mayhem (07-01-2015)
#9
07-01-2015, 12:27 PM
OK, then I think we have found the culprit.

Thanks!

The downside of being self-taught is that I'm not in the habit of checking for tool wear b/c when I was learning, they broke loooooong before they got dull.
Reply
Thanks given by:


Messages In This Thread
Slitting saw problem - by Roadracer_Al - 06-28-2015, 01:59 PM
RE: Slitting saw problem - by DaveH - 06-28-2015, 04:52 PM
RE: Slitting saw problem - by PixMan - 06-28-2015, 07:11 PM
RE: Slitting saw problem - by TomG - 06-28-2015, 08:42 PM
RE: Slitting saw problem - by Mayhem - 06-29-2015, 06:06 AM
RE: Slitting saw problem - by Roadracer_Al - 06-30-2015, 12:07 AM
RE: Slitting saw problem - by PixMan - 06-30-2015, 06:15 AM
RE: Slitting saw problem - by DaveH - 06-30-2015, 07:18 AM
RE: Slitting saw problem - by Roadracer_Al - 07-01-2015, 12:27 PM



Users browsing this thread: 1 Guest(s)