MetalworkingFun Forum › Machining › How-To's v
How to make threads

Thread Modes
How to make threads
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#6
07-15-2015, 01:35 PM
There's also a 3 sided screw that is thread forming. It will mushroom a bit, so maybe start it from the "wrong" side to get threads formed towards the inside?
You might get two, or even three threads in that thin stock.
Reply
Thanks given by:


Messages In This Thread
How to make threads - by racker - 07-11-2015, 05:40 PM
RE: How to make threads - by Roadracer_Al - 07-12-2015, 12:30 AM
RE: How to make threads - by Pete O - 07-12-2015, 07:37 AM
RE: How to make threads - by PixMan - 07-12-2015, 09:27 AM
RE: How to make threads - by Roadracer_Al - 07-12-2015, 12:06 PM
RE: How to make threads - by Sunset Machine - 07-15-2015, 01:35 PM



Users browsing this thread: 1 Guest(s)