MetalworkingFun Forum › Machining › General Metalworking Discussion v
looking to purchase some tooling

Thread Modes
looking to purchase some tooling
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#7
07-14-2015, 03:55 PM
(07-14-2015, 01:49 PM)Sunset Machine Wrote: Here's the problem I have with my 4" - it wasn't on a swivel, but has mounting lugs that puts the vice 90 degrees to the norm. You can see how it might hit the column. 
I've been tempted to hack the lug off, notch the column, or buy another vice... Smile

Why not just move the vice toward you one slot?  17428

Ed
Reply
Thanks given by:


Messages In This Thread
looking to purchase some tooling - by Kennyv - 07-14-2015, 09:48 AM
RE: looking to purchase some tooling - by JScott - 07-14-2015, 10:13 AM
RE: looking to purchase some tooling - by Shawn - 07-14-2015, 11:06 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 11:23 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 03:55 PM
RE: looking to purchase some tooling - by Vinny - 07-14-2015, 03:57 PM
RE: looking to purchase some tooling - by Kennyv - 07-14-2015, 11:09 PM
RE: looking to purchase some tooling - by Vinny - 07-15-2015, 04:01 PM
RE: looking to purchase some tooling - by Dr Stan - 07-15-2015, 04:05 PM
RE: looking to purchase some tooling - by Dr Stan - 07-17-2015, 10:05 AM
RE: looking to purchase some tooling - by Kennyv - 07-17-2015, 01:05 PM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 07:22 AM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 10:35 AM



Users browsing this thread: 1 Guest(s)