looking to purchase some tooling
#9
Right on Ed , hey Vinnie you know that's the most practical advise you have given besides not getting rid of the Beer fridge .
Shawn that " Glacern is a nice vise looked at a few of them today as well as Wiltons and Kurts a bit much for my needs but I like em very much ... Did some ebay shopping today didn't see much and have to consider shipping costs too. Now I did call PM today looks like they are out of 6" Homge which IMo not too shabby for the Money .. but the 5 inch really is a 4.5" with 5 width . So looks like another dilemma . Some guys are saying 6 inch is way to go ..But again I need to hear from other Folks that concur . Hate to get a vice that will be limited even if I make extended jaws ect.. But mostly don't want to waist the moneys on anchor weights either.
Reply
Thanks given by:


Messages In This Thread
looking to purchase some tooling - by Kennyv - 07-14-2015, 09:48 AM
RE: looking to purchase some tooling - by JScott - 07-14-2015, 10:13 AM
RE: looking to purchase some tooling - by Shawn - 07-14-2015, 11:06 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 11:23 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 03:55 PM
RE: looking to purchase some tooling - by Vinny - 07-14-2015, 03:57 PM
RE: looking to purchase some tooling - by Kennyv - 07-14-2015, 11:09 PM
RE: looking to purchase some tooling - by Vinny - 07-15-2015, 04:01 PM
RE: looking to purchase some tooling - by Dr Stan - 07-15-2015, 04:05 PM
RE: looking to purchase some tooling - by Dr Stan - 07-17-2015, 10:05 AM
RE: looking to purchase some tooling - by Kennyv - 07-17-2015, 01:05 PM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 07:22 AM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 10:35 AM



Users browsing this thread: 1 Guest(s)