MetalworkingFun Forum › Machining › Metrology v
Cylindrical Square

Thread Modes
Cylindrical Square
wawoodman Offline
Junior
****
Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA
#14
11-04-2015, 10:43 AM (This post was last modified: 11-04-2015, 10:45 AM by wawoodman.)
Way to make me feel stupid, guys! I just ordered one from Shars. <bang head against wall>

Keith Ruckert has a video of using one to tram a mill head. If it's good enough for him, it ought to be good enough for me!
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
Cylindrical Square - by EdK - 08-08-2015, 05:49 PM
RE: Cylindrical Square - by f350ca - 08-08-2015, 06:48 PM
RE: Cylindrical Square - by EdK - 08-08-2015, 10:56 PM
RE: Cylindrical Square - by Mayhem - 08-09-2015, 04:41 AM
RE: Cylindrical Square - by EdK - 08-09-2015, 09:49 AM
RE: Cylindrical Square - by ieezitin - 08-09-2015, 06:54 AM
RE: Cylindrical Square - by EdK - 08-09-2015, 08:58 AM
RE: Cylindrical Square - by dallen - 08-09-2015, 10:54 AM
RE: Cylindrical Square - by EdK - 08-14-2015, 02:44 PM
RE: Cylindrical Square - by PixMan - 08-16-2015, 07:59 AM
RE: Cylindrical Square - by Mayhem - 10-30-2015, 01:39 AM
RE: Cylindrical Square - by Highpower - 10-30-2015, 10:50 AM
RE: Cylindrical Square - by Mayhem - 10-30-2015, 07:13 PM
RE: Cylindrical Square - by wawoodman - 11-04-2015, 10:43 AM
RE: Cylindrical Square - by EdK - 11-04-2015, 05:04 PM
RE: Cylindrical Square - by wawoodman - 11-05-2015, 09:19 PM



Users browsing this thread: 1 Guest(s)