12-21-2016, 04:30 PM
Hi Guys
This must be getting boring for some of U.
Do regret that.
However, there's an interesting preamble to this we posted elsewhere.
Be that as it may, these are much smaller ones we fabricated from "Mystery Steel", which we thoroughly enjoyed working on.
All in the learning curve for us, if U may.
The dimensions being different, we Threaded these to fine 1.0 mm Threads on the lathe, without any glitches, thankfully. The lathe behaved perfectly. In fact we did not like the fit of the first run at all and ran a second batch of the male parts which matched perfectly. And all that without using any Taps.
As for the Mystery Steel,it hardly required any polishing
And U can eyeball the results for Yourself
Thanks for "putting eyes" like thems would say.
aRM
This must be getting boring for some of U.
Do regret that.
However, there's an interesting preamble to this we posted elsewhere.
Be that as it may, these are much smaller ones we fabricated from "Mystery Steel", which we thoroughly enjoyed working on.
All in the learning curve for us, if U may.
The dimensions being different, we Threaded these to fine 1.0 mm Threads on the lathe, without any glitches, thankfully. The lathe behaved perfectly. In fact we did not like the fit of the first run at all and ran a second batch of the male parts which matched perfectly. And all that without using any Taps.
As for the Mystery Steel,it hardly required any polishing
And U can eyeball the results for Yourself
Thanks for "putting eyes" like thems would say.
aRM