MetalworkingFun Forum › Machining › General Metalworking Discussion v
ID needed for this tool

Thread Modes
ID needed for this tool
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
#6
08-16-2015, 08:09 AM
 This called a poising tool, its designed to balance a clock wheel to assure that it is not heavier on one side than another. 

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
ID needed for this tool - by Bill Gruby - 08-15-2015, 05:35 PM
RE: ID needed for this tool - by Bill Gruby - 08-15-2015, 07:05 PM
RE: ID needed for this tool - by dallen - 08-15-2015, 08:27 PM
RE: ID needed for this tool - by Bill Gruby - 08-15-2015, 09:17 PM
RE: ID needed for this tool - by dallen - 08-15-2015, 10:58 PM
RE: ID needed for this tool - by ieezitin - 08-16-2015, 08:09 AM



Users browsing this thread: 1 Guest(s)