Any Mathmatitions on line (lathe change wheels)
#5
Sounds like a good video project for the Sparey Dividing Head you made. You didn't give it away, did you? Make a mandrel to fit it and copy the gear. Maybe make a 63 and 64 tooth gears, use them to make a few imperial threads and evaluate the differences.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
RE: Any Mathmatitions on line (lathe change wheels) - by chucketn - 08-30-2015, 09:41 AM



Users browsing this thread: 1 Guest(s)