MetalworkingFun Forum › Machinery › Milling Machines v
RF-30 mill drill

Thread Modes
RF-30 mill drill
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#9
08-31-2015, 02:31 PM
(08-31-2015, 12:52 PM)Sunset Machine Wrote: I get it - this is your baby. Kinda brings a tear to my eye. Somewhere I saw one of these with the head laying sideways on the table for driving a boring bar.  The bar itself was attached to a loader bucket in the usual manner but coupled through u-joints and a shaft to the dead mill/drill in the back of a truck.

Sorry Sunset, I don't understand. 17428

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
RF-30 mill drill - by stevec - 08-30-2015, 08:10 AM
RE: RF-30 mill drill - by ieezitin - 08-30-2015, 09:18 AM
RE: RF-30 mill drill - by Sunset Machine - 08-30-2015, 09:41 AM
RE: RF-30 mill drill - by stevec - 08-30-2015, 02:50 PM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 08:36 AM
RE: RF-30 mill drill - by dallen - 08-31-2015, 09:19 AM
RE: RF-30 mill drill - by stevec - 08-31-2015, 11:50 AM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 12:52 PM
RE: RF-30 mill drill - by stevec - 08-31-2015, 02:31 PM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 03:36 PM
RE: RF-30 mill drill - by Roadracer_Al - 08-31-2015, 02:36 PM
RE: RF-30 mill drill - by ieezitin - 08-31-2015, 04:42 PM
RE: RF-30 mill drill - by stevec - 09-01-2015, 06:02 AM



Users browsing this thread: 1 Guest(s)