Starting work on Polymer Lowers
#7
Thanks Scrapmetal, that looks like something I could follow or at least get some good ideas. I did already start a polymer 80% using my drill press and the jig that it came with but soon realized that I should hold off until my mill came in. I'll see if I can finish that one off before I start another one. I have a few polymer and aluminum ones to do.
Reply
Thanks given by:


Messages In This Thread
Starting work on Polymer Lowers - by Thumb - 10-05-2015, 09:49 PM
RE: Starting work on Polymer Lowers - by Mayhem - 10-06-2015, 06:04 AM
RE: Starting work on Polymer Lowers - by Thumb - 10-06-2015, 08:55 AM
RE: Starting work on Polymer Lowers - by Thumb - 10-06-2015, 01:37 PM
RE: Starting work on Polymer Lowers - by Thumb - 10-07-2015, 10:31 PM



Users browsing this thread: 1 Guest(s)