The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Basic set of parallels
#1
finally had some time after needing to do maintenance work . Had a few projects all goin on at once  so fig id finish this one so I can work on needed mods for the machines.   Hers is a set of parallels for my   5” Homge vise to use on my  new PM932 .  . Nothing  special  needed a wider set . Started out with  a  pc of unknown stock , fly cut  cut blanks  face milled  started out  ½ thk  was going to make .437 didnt likem ended up millin down again settled  with 3/8 thickness. They are only within .0005 in the heights in which I did surface grind.  Was going to make a nice wooden box but than saw  I had  this box that would be perfect to house them.  Little cut  foam/ rubber hot clue  done deal. Well that’s about it on to the next project for the mill


Attached Files Thumbnail(s)
                       
Reply
Thanks given by:


Messages In This Thread
Basic set of parallels - by Kennyv - 10-17-2015, 02:40 PM
RE: Basic set of parallels - by Micktoon - 10-17-2015, 05:04 PM
RE: Basic set of parallels - by DaveH - 10-17-2015, 06:05 PM
RE: Basic set of parallels - by PixMan - 10-19-2015, 10:20 AM



Users browsing this thread: 1 Guest(s)