MetalworkingFun Forum › Machining › General Metalworking Discussion v
newbie needs help!

Thread Modes
newbie needs help!
wawoodman Offline
Junior
****
Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA
#10
10-24-2015, 09:30 PM
I've looked, as well. If there are any programs left, they're CNC, not manual.

Thanks for the suggestion, though.
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
newbie needs help! - by wawoodman - 10-21-2015, 11:31 AM
RE: newbie needs help! - by EdK - 10-21-2015, 04:09 PM
RE: newbie needs help! - by wawoodman - 10-21-2015, 04:14 PM
RE: newbie needs help! - by Sunset Machine - 10-21-2015, 04:55 PM
RE: newbie needs help! - by Mayhem - 10-21-2015, 06:49 PM
RE: newbie needs help! - by ieezitin - 10-21-2015, 07:32 PM
RE: newbie needs help! - by wawoodman - 10-22-2015, 08:11 PM
RE: newbie needs help! - by Roadracer_Al - 10-23-2015, 11:26 PM
RE: newbie needs help! - by Dr Stan - 10-24-2015, 05:18 PM
RE: newbie needs help! - by wawoodman - 10-24-2015, 09:30 PM



Users browsing this thread: 1 Guest(s)