MetalworkingFun Forum › Machinery › Milling Machines v
1 st Gear

Thread Modes
1 st Gear
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#11
11-07-2015, 08:16 AM
Yes, making a mate to see how they mesh would tell if you got the pitch diameter right. How did you measure it? There is a very good book on gear cutting in the workshop practice series that you may want to check out. It is available from the bookdepository.com.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
1 st Gear - by carkrazd - 11-06-2015, 01:30 PM
RE: 1 st Gear - by Roadracer_Al - 11-06-2015, 01:54 PM
RE: 1 st Gear - by wawoodman - 11-06-2015, 02:57 PM
RE: 1 st Gear - by Sunset Machine - 11-06-2015, 05:28 PM
RE: 1 st Gear - by Sunset Machine - 11-06-2015, 05:33 PM
RE: 1 st Gear - by Mayhem - 11-06-2015, 06:59 PM
RE: 1 st Gear - by TomG - 11-06-2015, 08:26 PM
RE: 1 st Gear - by carkrazd - 11-06-2015, 09:25 PM
RE: 1 st Gear - by Pete O - 11-06-2015, 10:52 PM
RE: 1 st Gear - by carkrazd - 11-06-2015, 10:57 PM
RE: 1 st Gear - by TomG - 11-07-2015, 08:16 AM
RE: 1 st Gear - by carkrazd - 11-07-2015, 08:38 AM
RE: 1 st Gear - by Sunset Machine - 11-07-2015, 11:26 AM



Users browsing this thread: 1 Guest(s)