Ever Seen One of These 2
#9
(11-09-2015, 06:20 AM)Mayhem Wrote: Pete - I initially thought of doing the valve timing on an engine, where you need three hands as you attempt to secure the locking nut without buggering up the valve clearance.

Darren, if you design one that could be finely controlled you'd be a billionaire in a very short time. Flat-rate techs would be beating down your door to get one. Smile

Till then I'll have to stick to the old reliable manual tool. Just used it the other day in fact.

[Image: YA8880.jpg]
Willie
Reply
Thanks given by:


Messages In This Thread
Ever Seen One of These 2 - by carkrazd - 11-08-2015, 10:46 PM
RE: Ever Seen One of These 2 - by wawoodman - 11-09-2015, 12:17 AM
RE: Ever Seen One of These 2 - by Highpower - 11-09-2015, 12:30 AM
RE: Ever Seen One of These 2 - by Dr Stan - 11-09-2015, 02:52 AM
RE: Ever Seen One of These 2 - by Pete O - 11-09-2015, 03:31 AM
RE: Ever Seen One of These 2 - by Mayhem - 11-09-2015, 06:20 AM
RE: Ever Seen One of These 2 - by Highpower - 11-09-2015, 02:39 PM
RE: Ever Seen One of These 2 - by carkrazd - 11-09-2015, 08:25 AM
RE: Ever Seen One of These 2 - by carkrazd - 11-09-2015, 08:51 AM
RE: Ever Seen One of These 2 - by TomG - 11-10-2015, 08:46 AM



Users browsing this thread: 2 Guest(s)