The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
"Vice Hold Downs"

Thread Modes
"Vice Hold Downs"
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#1
11-14-2015, 03:56 PM
Anybody use them? 17428

I was skimming though ebay last week and a used pair of Starrett 54C vice hold downs caught my eye. They were on a "buy it now" with not much time left and I made a low ball offer figuring it would go nowhere. To my surprise the seller accepted my offer about 10 -15 minutes later. Jawdrop

They arrived in today's mail. If you have them - how often do you find yourself using them?

Or are they just a solution to a problem that doesn't exist? Just curious. Chin
Willie
Reply
Thanks given by:


Messages In This Thread
"Vice Hold Downs" - by Highpower - 11-14-2015, 03:56 PM
RE: "Vice Hold Downs" - by EdK - 11-14-2015, 04:05 PM
RE: "Vice Hold Downs" - by Highpower - 11-14-2015, 06:18 PM
RE: "Vice Hold Downs" - by Dr Stan - 11-14-2015, 05:14 PM
RE: "Vice Hold Downs" - by Dr Stan - 11-14-2015, 10:29 PM
RE: "Vice Hold Downs" - by TomG - 11-15-2015, 11:23 AM
RE: "Vice Hold Downs" - by Pete O - 11-17-2015, 11:11 PM
RE: "Vice Hold Downs" - by PixMan - 11-19-2015, 04:35 AM
RE: "Vice Hold Downs" - by Sunset Machine - 11-19-2015, 10:54 AM
RE: "Vice Hold Downs" - by dallen - 11-19-2015, 11:52 AM
RE: "Vice Hold Downs" - by Vinny - 11-19-2015, 07:23 PM
RE: "Vice Hold Downs" - by Pete O - 11-23-2015, 05:40 PM



Users browsing this thread: 1 Guest(s)