MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Collets: to rack or not to rack

Thread Modes
Help Collets: to rack or not to rack
Vinny Offline
Another Whipping Boy
*******
Posts: 2,597
Threads: 99
Joined: Dec 2014
Location: Michigan
The following 1 user Likes Vinny's post:
aametalmaster (12-05-2015)
#8
11-17-2015, 09:45 PM
How about a large cutting board? They're HDPE and cheap. eg. Target has a set of 3 (8x11, 99x13 and 11x16) for $8.99. You could make alot of collet rack outta that. Prolly even get 'em cheaper at Walmart since Target isn't exactly the cheapest place around.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Website
Reply
Thanks given by:


Messages In This Thread
Collets: to rack or not to rack - by rleete - 11-16-2015, 05:19 PM
RE: Collets: to rack or not to rack - by EdK - 11-16-2015, 05:59 PM
RE: Collets: to rack or not to rack - by Hawkeye - 11-17-2015, 01:01 AM
RE: Collets: to rack or not to rack - by Dr Stan - 11-17-2015, 10:41 AM
RE: Collets: to rack or not to rack - by arvidj - 11-17-2015, 08:27 PM
RE: Collets: to rack or not to rack - by Vinny - 11-17-2015, 09:45 PM



Users browsing this thread: 1 Guest(s)