Soldering station?

[EdK]

OK Arvid, it appears you have lots of options that won't cost you an arm and a leg. Here's the one the guys at work recommended. It's only about $60 and I told them you were willing to pay more for a quality one. They said this one works as well as the more expensive ones.
Behind door number one.

http://www.amazon.com/dp/B00ITMPQS2?psc=1

I had looked for a hot air unit some months back and I found this one to be highly recommended and being of a bit higher quality than the lower cost made in China units. I haven't bought it yet but had planned to at some point.
Behind door number two.

http://gokimco.com/eclipse-pro-s-kit-ss-...oCK1_w_wcB

There are two other brands that are considered to be made for the industry rather than for the hobbyists. Quick and XYtronic.
Behind door number three.

http://www.mcmelectronics.com/product/QU...-/21-13210
http://www.xytronic-usa.com/shop/item.aspx?itemid=202

And then there's this one that is also supposed to be of higher quality but not quite up the the quality of a Hako or Weller but for a lot less money.
Behind door number four.

http://www.circuitspecialists.com/blackjack-solderwerks

I'm now leaning towards this one. I like the fact that it has a suction cup to lift the components off of the board once the solder is melted. It would be useful mainly for removing ICs.

http://www.circuitspecialists.com/bk4050.html

Hope this helps some.

Ed