12-01-2015, 01:56 PM
Friend of a friend, is selling a small heat treat furnace. It's an older manual control Thermolyne type 1400 bench top unit. I asked if it "works" and the answer was "yes..... but the temperature gauge doesn't." 
I am getting all this through my buddy (middle man) who I trust, but I have not actually seen this furnace or verified that it operates.
At $200 I think I am going to take a chance on it. It looks very clean and doesn't appear to have been abused. So the question is - is it worth "fixing" the original temp gauge display? Would it be too expensive to convert it over to digital control?
image3.jpg (Size: 15.09 KB / Downloads: 141)
I am getting all this through my buddy (middle man) who I trust, but I have not actually seen this furnace or verified that it operates.At $200 I think I am going to take a chance on it. It looks very clean and doesn't appear to have been abused. So the question is - is it worth "fixing" the original temp gauge display? Would it be too expensive to convert it over to digital control?
image3.jpg (Size: 15.09 KB / Downloads: 141)
Willie