The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
"Emergency" Spring collets - question.

Thread Modes
"Emergency" Spring collets - question.
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#1
Question  02-07-2016, 11:30 AM
Is there a "rule of thumb" for how far down a spring collet should be compressed before boring it to a desired size?   Smiley-think005

I have a set of Snap-On metric stud removers that I use, but I want a collet in 12mm x 1.75mm and Snap-On doesn't offer that size. I just bought an old collet off of eBay and want to bore it out and re-thread it to my desired size. But I don't know how much to squeeze it down before boring it.   17428

   

   
Willie
Reply
Thanks given by:


Messages In This Thread
"Emergency" Spring collets - question. - by Highpower - 02-07-2016, 11:30 AM



Users browsing this thread: 1 Guest(s)