MetalworkingFun Forum › Machining › General Metalworking Discussion v
LibreCAD squiggle trimming?

Thread Modes
LibreCAD squiggle trimming?
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#11
03-02-2016, 10:46 AM
Uh-oh. The BS detector went off when using LibreCAD just now.

Draw a line 3/16" long and then dimension it - .0074" it says.
Info shows the length as .1875"

LibreCAD, it appears to be untrustworthy. I've tried this several times.


Attached Files
.dxf   Untitled.dxf (Size: 11.4 KB / Downloads: 2)
Reply
Thanks given by:


Messages In This Thread
LibreCAD squiggle trimming? - by Sunset Machine - 02-26-2016, 01:12 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-26-2016, 02:34 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-27-2016, 09:37 AM
RE: LibreCAD squiggle trimming? - by EdK - 02-27-2016, 06:58 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-28-2016, 12:58 PM
RE: LibreCAD squiggle trimming? - by Sunset Machine - 03-02-2016, 10:46 AM
RE: LibreCAD squiggle trimming? - by rleete - 03-02-2016, 12:13 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-09-2016, 06:18 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-09-2016, 06:28 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-10-2016, 01:39 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-10-2016, 02:02 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-10-2016, 04:34 PM
RE: LibreCAD squiggle trimming? - by f350ca - 04-10-2016, 06:29 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-10-2016, 08:01 PM
RE: LibreCAD squiggle trimming? - by EdK - 04-11-2016, 07:09 AM
RE: LibreCAD squiggle trimming? - by Vinny - 04-11-2016, 04:09 PM



Users browsing this thread: