Making a duck call jig
#3
I made a little progress over the weekend.  This jig requires a 0.625" through hole.  I drilled a pilot hole 1/2" with a twist drill and then followed that with a 0.625" end mill.  It worked well but I had to peck "drill" the last portion of the hole because the end mill flutes filled with chips.

   

This is how it looks with the hole chamfered.

   
JScott, proud to be a member of MetalworkingFun Forum since Mar 2014.
Reply
Thanks given by:


Messages In This Thread
Making a duck call jig - by JScott - 02-29-2016, 04:04 PM
RE: Making a duck call jig - by DaveH - 02-29-2016, 06:31 PM
RE: Making a duck call jig - by JScott - 03-07-2016, 04:32 PM
RE: Making a duck call jig - by TomG - 03-07-2016, 07:46 PM
RE: Making a duck call jig - by JScott - 03-14-2016, 11:42 AM
RE: Making a duck call jig - by JScott - 03-17-2016, 12:34 PM
RE: Making a duck call jig - by Highpower - 03-17-2016, 12:52 PM
RE: Making a duck call jig - by JScott - 03-17-2016, 01:39 PM
RE: Making a duck call jig - by TomG - 03-17-2016, 07:13 PM
RE: Making a duck call jig - by JScott - 03-18-2016, 08:50 AM
RE: Making a duck call jig - by TomG - 03-18-2016, 09:16 AM
RE: Making a duck call jig - by JScott - 03-18-2016, 10:14 AM
RE: Making a duck call jig - by Highpower - 03-18-2016, 11:31 AM
RE: Making a duck call jig - by JScott - 03-18-2016, 11:44 AM
RE: Making a duck call jig - by Sunset Machine - 03-18-2016, 12:14 PM
RE: Making a duck call jig - by JScott - 03-18-2016, 12:50 PM



Users browsing this thread: 1 Guest(s)