Electronics Question (again...)
#13
Just out of interest - what is the issue with the lamp (big picture)? Is it that you finish machining a part and then find out three days later that you have left the unit switched on? If so, just kill the power to the machine after use. When I kill my power, the spindle motor, feed motor, coolant pump (not present yet) and the DRO all go off. Simple Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Electronics Question (again...) - by Highpower - 03-11-2016, 01:40 PM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 05:01 PM
RE: Electronics Question (again...) - by f350ca - 03-11-2016, 06:16 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:28 PM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 08:24 AM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 07:43 PM
RE: Electronics Question (again...) - by Mayhem - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 08:35 AM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 10:53 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 09:27 AM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 03:04 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 07:27 PM
RE: Electronics Question (again...) - by pepi - 03-19-2016, 07:23 AM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 12:14 PM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 03:23 PM



Users browsing this thread: 1 Guest(s)