04-18-2016, 07:42 AM
9" from spindle to table is not much room. I got a set of stub drills, but not sure if that's going to be much help on that mill.
|
Not the sharpet bit in the box
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Not the sharpet bit in the box - by kennyg - 04-17-2016, 11:11 PM
RE: Not the sharpet bit in the box - by schor - 04-18-2016, 07:42 AM
RE: Not the sharpet bit in the box - by Roadracer_Al - 04-18-2016, 02:38 PM
RE: Not the sharpet bit in the box - by kennyg - 04-18-2016, 03:32 PM
RE: Not the sharpet bit in the box - by Dr Stan - 04-18-2016, 07:22 PM
RE: Not the sharpet bit in the box - by ieezitin - 04-18-2016, 07:44 PM
|
Users browsing this thread: 1 Guest(s)