MetalworkingFun Forum › Machinery › Milling Machines v
Z axis setter gauge

Thread Modes
Z axis setter gauge
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#7
04-19-2016, 06:55 PM
My first impression is that you might need to go with a tenth reading indicator and a shallower taper to get smooth enough operation. The 45º angle in your design will place a fair amount of side load on the plunger.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Z axis setter gauge - by JScott - 04-19-2016, 02:57 PM
RE: Z axis setter gauge - by DaveH - 04-19-2016, 03:08 PM
RE: Z axis setter gauge - by JScott - 04-19-2016, 03:15 PM
RE: Z axis setter gauge - by Vinny - 04-19-2016, 03:15 PM
RE: Z axis setter gauge - by JScott - 04-19-2016, 03:38 PM
RE: Z axis setter gauge - by ieezitin - 04-19-2016, 03:28 PM
RE: Z axis setter gauge - by TomG - 04-19-2016, 06:55 PM
RE: Z axis setter gauge - by PixMan - 04-20-2016, 06:39 AM
RE: Z axis setter gauge - by JScott - 04-20-2016, 08:07 AM
RE: Z axis setter gauge - by f350ca - 04-20-2016, 01:05 PM



Users browsing this thread: