MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Walter Tool Catalogue

Thread Modes
Walter Tool Catalogue
ronboult Offline
Freshman
**
Posts: 29
Threads: 3
Joined: Aug 2013
Location: Brisbane Australia
#21
06-17-2016, 08:29 PM
Thanks Vinny
Your solution may be the easiest. However I don't think a tail stock centre will run true enough in the threaded hole in the face mill end. Either end threaded holes for that matter hence Highpowers suggestion for a plug.
ronboult, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:


Messages In This Thread
Walter Tool Catalogue - by ronboult - 04-28-2016, 11:28 PM
RE: Walter Tool Catalogue - by Dr Stan - 04-28-2016, 11:31 PM
RE: Walter Tool Catalogue - by ronboult - 04-28-2016, 11:55 PM
RE: Walter Tool Catalogue - by Mayhem - 04-29-2016, 05:40 AM
RE: Walter Tool Catalogue - by ronboult - 04-29-2016, 06:24 AM
RE: Walter Tool Catalogue - by Mayhem - 04-29-2016, 07:22 AM
RE: Walter Tool Catalogue - by PixMan - 04-29-2016, 08:22 AM
RE: Walter Tool Catalogue - by ronboult - 04-30-2016, 04:50 AM
RE: Walter Tool Catalogue - by Mayhem - 04-30-2016, 08:06 AM
RE: Walter Tool Catalogue - by PixMan - 05-26-2016, 07:44 PM
RE: Walter Tool Catalogue - by ronboult - 05-29-2016, 05:18 AM
RE: Walter Tool Catalogue - by PixMan - 05-30-2016, 08:21 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:41 AM
RE: Walter Tool Catalogue - by Highpower - 06-17-2016, 09:16 AM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:51 AM
RE: Walter Tool Catalogue - by PixMan - 06-17-2016, 04:25 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:56 PM
RE: Walter Tool Catalogue - by Highpower - 06-17-2016, 08:15 PM
RE: Walter Tool Catalogue - by Vinny - 06-17-2016, 06:13 PM
RE: Walter Tool Catalogue - by Mayhem - 06-17-2016, 08:16 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 08:29 PM



Users browsing this thread: 1 Guest(s)