05-10-2016, 04:42 PM
Nice job on the tapers. Is the steel hot rolled, or just rusty? Or can you tell?
A good way to check your taper is to use a MT socket and some Prussian blue. Just put a light coat of blue on the taper, stick it in the socket and twist. The blue will rub off on the tighter end.
Tom
A good way to check your taper is to use a MT socket and some Prussian blue. Just put a light coat of blue on the taper, stick it in the socket and twist. The blue will rub off on the tighter end.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)