MetalworkingFun Forum › Machinery › Lathes v
Installing QCTP to the Kobe lathe

Thread Modes
Installing QCTP to the Kobe lathe
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#6
05-25-2016, 05:43 AM
(05-25-2016, 03:41 AM)Pete O Wrote: By the way, I had been wondering why everyone was saying they replace the dog-point setscrews in the holders. I assume it's because there isn't an allen key known to man that actually fits the chicom screws?

No, it's because they're made of cheese.

Ed
Reply
Thanks given by:


Messages In This Thread
Installing QCTP to the Kobe lathe - by Pete O - 05-24-2016, 06:39 AM
RE: Installing QCTP to the Kobe lathe - by Mayhem - 05-24-2016, 06:54 AM
RE: Installing QCTP to the Kobe lathe - by Vinny - 05-24-2016, 04:45 PM
RE: Installing QCTP to the Kobe lathe - by Pete O - 05-25-2016, 03:36 AM
RE: Installing QCTP to the Kobe lathe - by Pete O - 05-25-2016, 03:41 AM
RE: Installing QCTP to the Kobe lathe - by EdK - 05-25-2016, 05:43 AM
RE: Installing QCTP to the Kobe lathe - by PixMan - 05-25-2016, 06:56 AM
RE: Installing QCTP to the Kobe lathe - by Pete O - 05-29-2016, 08:36 AM
RE: Installing QCTP to the Kobe lathe - by Mayhem - 05-29-2016, 09:05 AM



Users browsing this thread: 1 Guest(s)