MetalworkingFun Forum › Machining › General Metalworking Discussion v
Making Dickson QCTP holders

Thread Modes
Making Dickson QCTP holders
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#10
09-04-2016, 07:35 PM
I actually checked mine, using a couple of endmills in place of dowel pins. The distance between the centre of the v grooves is exactly 100mm. Looks like we have then same tool holders.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Making Dickson QCTP holders - by Rickabilly - 07-29-2016, 02:36 AM
RE: Making Dickson QCTP holders - by Mayhem - 07-29-2016, 05:43 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-03-2016, 11:49 PM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 12:59 AM
RE: Making Dickson QCTP holders - by awemawson - 08-04-2016, 02:54 AM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 06:27 AM
RE: Making Dickson QCTP holders - by Rickabilly - 08-04-2016, 07:07 PM
RE: Making Dickson QCTP holders - by krv3000 - 08-04-2016, 02:52 PM
RE: Making Dickson QCTP holders - by Mayhem - 08-04-2016, 07:22 PM
RE: Making Dickson QCTP holders - by Mayhem - 09-04-2016, 07:35 PM



Users browsing this thread: 1 Guest(s)