|
Macson 18" shaper
|
09-28-2016, 09:57 AM
(09-28-2016, 09:17 AM)Sunset Machine Wrote:(09-22-2016, 05:33 PM)ieezitin Wrote: They have had grinding heads on shapers since the 1920ties, i have buried in my archives articles explaining it.. if i come across it ill post it. WOW! That's one honking big grinding wheel. But then its certainly a way to achieve high SFPM at low RPMS. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Macson 18" shaper - by Pete O - 09-21-2016, 02:41 AM
RE: Macson 18" shaper - by pepi - 09-21-2016, 06:59 AM
RE: Macson 18" shaper - by Dr Stan - 09-21-2016, 09:36 AM
RE: Macson 18" shaper - by Mike E. - 09-21-2016, 12:33 PM
RE: Macson 18" shaper - by Dr Stan - 09-21-2016, 03:00 PM
RE: Macson 18" shaper - by Pete O - 09-21-2016, 07:03 PM
RE: Macson 18" shaper - by ieezitin - 09-22-2016, 05:33 PM
RE: Macson 18" shaper - by Sunset Machine - 09-28-2016, 09:17 AM
RE: Macson 18" shaper - by Dr Stan - 09-28-2016, 09:57 AM
RE: Macson 18" shaper - by Sunset Machine - 09-29-2016, 08:25 AM
RE: Macson 18" shaper - by Pete O - 09-27-2016, 11:07 PM
RE: Macson 18" shaper - by f350ca - 09-28-2016, 10:01 AM
RE: Macson 18" shaper - by Pete O - 09-28-2016, 06:28 PM
RE: Macson 18" shaper - by Pete O - 09-30-2016, 07:19 AM
RE: Macson 18" shaper - by Dr Stan - 09-30-2016, 04:38 PM
RE: Macson 18" shaper - by Sunset Machine - 10-01-2016, 08:40 AM
RE: Macson 18" shaper - by Roadracer_Al - 10-02-2016, 11:41 AM
|
