|
Lathe Radius Attachment
|
 (10-08-2016, 08:55 PM)Hawkeye Wrote: "The handle also serves as the setscrew to hold the handle and hub onto the top of the vertical shaft." Nice job  'Why is the "vertical shaft" so long (tall)? Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe Radius Attachment - by Hawkeye - 10-08-2016, 08:55 PM
RE: Lathe Radius Attachment - by Vinny - 10-08-2016, 09:41 PM
RE: Lathe Radius Attachment - by stevec - 10-09-2016, 07:07 AM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-09-2016, 11:46 AM
RE: Lathe Radius Attachment - by DaveH - 10-09-2016, 03:44 PM
RE: Lathe Radius Attachment - by krv3000 - 10-09-2016, 06:39 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-09-2016, 09:15 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-12-2016, 05:25 PM
RE: Lathe Radius Attachment - by pepi - 10-13-2016, 06:07 AM
RE: Lathe Radius Attachment - by wawoodman - 10-13-2016, 03:22 PM
RE: Lathe Radius Attachment - by Roadracer_Al - 10-13-2016, 03:57 PM
RE: Lathe Radius Attachment - by Hawkeye - 10-13-2016, 10:26 PM
|
