MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe chucks

Thread Modes
Lathe chucks
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
The following 1 user Likes the penguin's post:
rleete (11-21-2016)
#9
11-18-2016, 04:44 PM
About 5 years ago, I traded my Albrecht keyless chuck for a Rohm keyed chuck, of the same size, I never felt sorry about the trade. To me Albrecht drill chucks are like Kurt vise, good quality, but way over priced for what you get.
jack
Reply
Thanks given by:


Messages In This Thread
Lathe chucks - by pepi - 11-12-2016, 09:19 PM
RE: Lathe chucks - by TomG - 11-12-2016, 09:51 PM
RE: Lathe chucks - by the penguin - 11-12-2016, 09:53 PM
RE: Lathe chucks - by pepi - 11-12-2016, 10:57 PM
RE: Lathe chucks - by the penguin - 11-12-2016, 10:04 PM
RE: Lathe chucks - by ieezitin - 11-13-2016, 11:58 AM
RE: Lathe chucks - by pepi - 11-17-2016, 07:36 AM
RE: Lathe chucks - by Roadracer_Al - 11-18-2016, 02:48 PM
RE: Lathe chucks - by the penguin - 11-18-2016, 04:44 PM
RE: Lathe chucks - by Dr Stan - 12-10-2016, 01:44 AM



Users browsing this thread: 1 Guest(s)