11-25-2016, 06:02 PM
I'm guessing since the surfaces appear to be ground, it must be hardened to some degree. I posed the question to the distributor and will let you know what they say, if anything.
Ed
Ed
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
HHIP 3901-5032 ER-32 Collet Chuck
HHIP 3901-5032 ER-32 Collet Chuck
|
HHIP 3901-5032 ER-32 Collet Chuck
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
HHIP 3901-5032 ER-32 Collet Chuck - by chucketn - 11-25-2016, 03:32 PM
RE: HHIP 3901-5032 ER-32 Collet Chuck - by EdK - 11-25-2016, 06:02 PM
RE: HHIP 3901-5032 ER-32 Collet Chuck - by chucketn - 11-25-2016, 06:45 PM
RE: HHIP 3901-5032 ER-32 Collet Chuck - by EdK - 11-25-2016, 07:02 PM
|
Users browsing this thread: 1 Guest(s)