Mach 3 Question

Thread Modes

Mach 3 Question

Hawkeye Offline

Junior

Posts: 531
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

12-02-2016, 11:23 PM

I've had better results with lost foam than sand casting, but that would be a good idea for multiple copies. Everything's a possibility.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

« Next Oldest | Next Newest »

Messages In This Thread

Mach 3 Question - by Hawkeye - 11-25-2016, 09:26 PM

RE: Mach 3 Question - by arvidj - 11-26-2016, 09:09 AM

RE: Mach 3 Question - by Hawkeye - 11-26-2016, 11:52 PM

RE: Mach 3 Question - by arvidj - 11-27-2016, 08:42 AM

RE: Mach 3 Question - by Hawkeye - 11-28-2016, 12:40 AM

RE: Mach 3 Question - by Mayhem - 11-28-2016, 06:50 AM

RE: Mach 3 Question - by Hawkeye - 12-02-2016, 11:23 PM

Users browsing this thread: 1 Guest(s)