11-29-2016, 07:57 PM
I would think you'd be fine with aluminum on a small mill. 
Ed
Ed
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
Low profile clamp for 4” Vertex RT
Low profile clamp for 4” Vertex RT
|
Low profile clamp for 4” Vertex RT
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Low profile clamp for 4” Vertex RT - by chucketn - 11-29-2016, 01:45 PM
RE: Low profile clamp for 4” Vertex RT - by Vinny - 11-29-2016, 02:10 PM
RE: Low profile clamp for 4” Vertex RT - by chucketn - 11-29-2016, 02:18 PM
RE: Low profile clamp for 4” Vertex RT - by EdK - 11-29-2016, 07:57 PM
|
Users browsing this thread: 1 Guest(s)