Lathe and mill benches
#1
I'm looking for plans for a nice, simple to make, sturdy(wood) work bench for my mill and lathe. I would prefer drawers for storage to cabinets. I'm not very good at designing these things by myself. My current mill bench is a section of old kitchen cabinet that was in my garage when I bought my house. It is wobbly and inefficient for storage.
I built a 8'x18' extension on the back of my garage for my shop(with help).
I have been searching the web and found a few, but not getting enough detail to start building.
I also plan to build several wall shelf units that will be hung on French cleats.
I have found a book by Tom Clark, titled 'Practical Shop Cabinets' for under $20. Anybody have this book?
I'm open to paid for plans if relatively cheap, and easy for a dummy like me to follow.
I have the usual homeowners/diy tools, skill saw, table saw, router, etc. Suggestions welcome...

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Lathe and mill benches - by chucketn - 12-01-2016, 11:21 AM
RE: Lathe and mill benches - by EdK - 12-01-2016, 01:28 PM
RE: Lathe and mill benches - by Mike E. - 12-01-2016, 02:16 PM
RE: Lathe and mill benches - by chucketn - 12-01-2016, 02:53 PM
RE: Lathe and mill benches - by Vinny - 12-01-2016, 05:29 PM
RE: Lathe and mill benches - by chucketn - 12-01-2016, 07:40 PM
RE: Lathe and mill benches - by rleete - 12-02-2016, 12:36 PM
RE: Lathe and mill benches - by Dr Stan - 12-01-2016, 05:54 PM
RE: Lathe and mill benches - by schor - 12-01-2016, 08:15 PM
RE: Lathe and mill benches - by Dr Stan - 12-01-2016, 08:27 PM
RE: Lathe and mill benches - by Vinny - 12-02-2016, 06:34 PM
RE: Lathe and mill benches - by Dr Stan - 12-02-2016, 09:24 PM



Users browsing this thread: 1 Guest(s)