MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Indexing tool types, I'm confused!

Thread Modes
Indexing tool types, I'm confused!
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Bigtrev (01-09-2017)
#9
01-07-2017, 06:22 PM
(01-07-2017, 06:02 PM)f350ca Wrote: I agree you'll probably use the left hand one the most

I think you mean the right hand which is angled towards the chuck, to the left. It make no sense why they call it a right hand tool when it angles to the left but I'm sure there's a good reason. Ken could educate us but he bailed.  Sad

Ed
Reply
Thanks given by:


Messages In This Thread
RE: Indexing tool types, I'm confused! - by EdK - 01-07-2017, 04:31 PM
RE: Indexing tool types, I'm confused! - by EdK - 01-07-2017, 05:41 PM
RE: Indexing tool types, I'm confused! - by Vinny - 01-07-2017, 06:05 PM
RE: Indexing tool types, I'm confused! - by Vinny - 01-07-2017, 06:08 PM
RE: Indexing tool types, I'm confused! - by EdK - 01-07-2017, 06:22 PM
RE: Indexing tool types, I'm confused! - by Vinny - 01-07-2017, 10:11 PM
RE: Indexing tool types, I'm confused! - by EdK - 01-07-2017, 10:15 PM
RE: Indexing tool types, I'm confused! - by Vinny - 01-08-2017, 03:53 PM
RE: Indexing tool types, I'm confused! - by Vinny - 01-08-2017, 07:48 PM



Users browsing this thread: 1 Guest(s)