First real project on the mill
#6
Hi Dan,

My problem was the quill twists a small amount when lowered so it causes the DRO scale to bind. It's not a mounting hardware problem, it's quill slop that's causing the problem. I've yet to figure out a solution.

Ed
Reply
Thanks given by:


Messages In This Thread
First real project on the mill - by DanH - 04-25-2012, 02:22 PM
RE: First real project on the mill - by EdK - 04-25-2012, 03:43 PM
RE: First real project on the mill - by krv3000 - 04-25-2012, 05:13 PM
RE: First real project on the mill - by DanH - 04-25-2012, 05:21 PM
RE: First real project on the mill - by EdK - 04-25-2012, 06:39 PM
RE: First real project on the mill - by DaveH - 04-25-2012, 08:49 PM
RE: First real project on the mill - by DanH - 04-27-2012, 12:43 PM
RE: First real project on the mill - by RobWilson - 04-26-2012, 12:29 PM
RE: First real project on the mill - by ETC57 - 04-26-2012, 01:17 PM
RE: First real project on the mill - by DanH - 04-27-2012, 12:41 PM
RE: First real project on the mill - by Dave J - 05-09-2012, 11:16 AM



Users browsing this thread: 1 Guest(s)