06-07-2017, 07:23 AM
What is the tailstock taper?
My old lathe had a 3" through hole with some form of taper that (like Greg's lathe) would have had an adaptor to make it useful. Like Greg, I've always just turned a piece of scrap to a taper when turning between centres.
My old lathe had a 3" through hole with some form of taper that (like Greg's lathe) would have had an adaptor to make it useful. Like Greg, I've always just turned a piece of scrap to a taper when turning between centres.
Hunting American dentists since 2015.