MetalworkingFun Forum › Machinery › Lathes v
[HELP] What's mt taper?

Thread Modes
Help What's mt taper?
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 1 user Likes f350ca's post:
Andy T (06-07-2017)
#15
06-07-2017, 08:01 AM
My lathe must have an odd taper too. The manual lists the headstock taper as #6, but has a 3 inch through hole. According to the chart you posted the inside of the bushing must be #6.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
What's mt taper? - by Andy T - 06-06-2017, 03:27 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 03:34 AM
RE: What's mt taper? - by Andy T - 06-06-2017, 03:54 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 04:20 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 04:25 AM
RE: What's mt taper? - by Mayhem - 06-06-2017, 06:38 AM
RE: What's mt taper? - by Andy T - 06-06-2017, 03:33 PM
RE: What's mt taper? - by awemawson - 06-06-2017, 03:44 PM
RE: What's mt taper? - by texx - 06-06-2017, 04:07 PM
RE: What's mt taper? - by Roadracer_Al - 06-06-2017, 04:29 PM
RE: What's mt taper? - by texx - 06-06-2017, 05:34 PM
RE: What's mt taper? - by f350ca - 06-06-2017, 06:06 PM
RE: What's mt taper? - by Andy T - 06-07-2017, 04:06 AM
RE: What's mt taper? - by Mayhem - 06-07-2017, 07:23 AM
RE: What's mt taper? - by Andy T - 06-07-2017, 08:39 AM
RE: What's mt taper? - by f350ca - 06-07-2017, 08:01 AM
RE: What's mt taper? - by Mayhem - 06-07-2017, 08:43 AM



Users browsing this thread: 1 Guest(s)