Mill draw-bar

Thread Modes

Mill draw-bar

b4dyc

Junior Swarf-making student

Posts: 68
Threads: 6
Joined: Apr 2012
Location: Hertfordshire, England

05-21-2012, 07:33 AM

Hi,
Yeah have progressed a bit further with it, lets see if i can add pictures here Ouch

Turned the bar between centres in the trusty Myford
[Image: 2012-05-02114819.jpg]

Arrived at the point where i needed the correct size of thread that i asked about
[Image: 2012-05-21115625.jpg]

Popped the thread on
[Image: 2012-05-21114332-1.jpg]

Now I try it on the new MT3 collet Success ! Rotfl

All that is needed now is my jig completing so that i can add the squared off end for the spanner to fit
[Image: 2012-05-21114419-1.jpg]

Andy

b4dyc, proud to be a member of MetalworkingFun Forum since Apr 2012. Oh yeah

« Next Oldest | Next Newest »

Messages In This Thread

Mill draw-bar - by b4dyc - 05-01-2012, 03:22 PM

RE: Mill draw-bar - by Tony Wells - 05-01-2012, 03:33 PM

RE: Mill draw-bar - by b4dyc - 05-01-2012, 03:48 PM

RE: Mill draw-bar - by doubleboost - 05-01-2012, 04:08 PM

RE: Mill draw-bar - by b4dyc - 05-01-2012, 04:41 PM

RE: Mill draw-bar - by doubleboost - 05-01-2012, 04:47 PM

RE: Mill draw-bar - by Mayhem - 05-01-2012, 09:48 PM

RE: Mill draw-bar - by DaveH - 05-20-2012, 06:23 PM

RE: Mill draw-bar - by b4dyc - 05-21-2012, 07:33 AM

RE: Mill draw-bar - by DaveH - 05-22-2012, 02:03 PM

RE: Mill draw-bar - by Highpower - 05-22-2012, 04:17 PM

RE: Mill draw-bar - by b4dyc - 05-23-2012, 02:22 AM

RE: Mill draw-bar - by Highpower - 05-23-2012, 06:51 AM

RE: Mill draw-bar - by stevec - 05-23-2012, 07:32 AM

RE: Mill draw-bar - by krv3000 - 05-23-2012, 07:38 PM

RE: Mill draw-bar - by b4dyc - 05-24-2012, 07:55 AM

RE: Mill draw-bar - by Highpower - 05-24-2012, 01:54 PM

Users browsing this thread: 1 Guest(s)