MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Fitting a 5C Collet Chuck

Thread Modes
Fitting a 5C Collet Chuck
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#9
06-12-2017, 05:33 PM
(06-12-2017, 06:46 AM)the penguin Wrote: Knowing what I know now, and was going to do it again, I would have gone ER40, instead.

Yup, I agree Jack. That's what I did but I think Trevor has the 5C collets already.

Ed
Reply
Thanks given by:


Messages In This Thread
Fitting a 5C Collet Chuck - by Cross Slide - 06-09-2017, 10:18 PM
RE: Fitting a 5C Collet Chuck - by EdK - 06-09-2017, 10:59 PM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:22 PM
RE: Fitting a 5C Collet Chuck - by ieezitin - 06-10-2017, 09:19 AM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:07 PM
RE: Fitting a 5C Collet Chuck - by Mayhem - 06-10-2017, 09:40 AM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:16 PM
RE: Fitting a 5C Collet Chuck - by the penguin - 06-12-2017, 06:46 AM
RE: Fitting a 5C Collet Chuck - by EdK - 06-12-2017, 05:33 PM
RE: Fitting a 5C Collet Chuck - by the penguin - 06-13-2017, 07:58 AM
RE: Fitting a 5C Collet Chuck - by Dr Stan - 06-13-2017, 12:37 PM



Users browsing this thread: 3 Guest(s)