The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Aluminum Fixture Plate

Thread Modes
Aluminum Fixture Plate
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
The following 7 users Like the penguin's post:
f350ca (08-12-2017), Dozer56 (08-12-2017), Mike E. (08-12-2017), Mayhem (08-12-2017), EdK (08-12-2017), Highpower (08-12-2017), Roadracer_Al (08-14-2017)
#1
08-11-2017, 10:39 PM
I have a few steel fixture plates, very handy, but I need a bigger one. So I made a 12" x 24" x 1/2" fixture plate, with (126) 3/8"-16 and (127) 1/2"-13 threaded holes. I have to roll over the edges with the 1/8" bit, in the router, to clean up the sharp edges.


Attached Files Thumbnail(s)
   
jack
Reply
Thanks given by:


Messages In This Thread
Aluminum Fixture Plate - by the penguin - 08-11-2017, 10:39 PM
RE: Aluminum Fixture Plate - by randyc - 08-12-2017, 06:43 PM
RE: Aluminum Fixture Plate - by f350ca - 08-12-2017, 07:23 PM
RE: Aluminum Fixture Plate - by randyc - 08-12-2017, 09:50 PM
RE: Aluminum Fixture Plate - by Highpower - 08-12-2017, 10:29 PM
RE: Aluminum Fixture Plate - by f350ca - 08-13-2017, 08:01 AM
RE: Aluminum Fixture Plate - by randyc - 08-13-2017, 04:37 PM
RE: Aluminum Fixture Plate - by the penguin - 08-13-2017, 05:07 PM
RE: Aluminum Fixture Plate - by the penguin - 08-22-2017, 10:04 PM



Users browsing this thread: 1 Guest(s)