unloved micrometer
#21
Hello All,

I can't remember which of our members it was,(sorry), but as far as "parts small enough to fit in a tank" go, someone recently showed an excellent idea using some plastic sheet and an appropriately sized Cardboard box to make a suitably sized "dipping tank" I suppose a wooden frame would be just as suitable, my point is, anything is small enough to fit in a tank using this method.

Best regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
unloved micrometer - by mikecwik - 05-03-2012, 07:05 AM
RE: unloved micrometer - by DaveH - 05-03-2012, 07:16 AM
RE: unloved micrometer - by EdK - 05-03-2012, 07:19 AM
RE: unloved micrometer - by Rickabilly - 06-14-2012, 04:17 PM
RE: unloved micrometer - by stevec - 06-14-2012, 04:58 PM
RE: unloved micrometer - by EdK - 06-14-2012, 05:15 PM
RE: unloved micrometer - by DaveH - 06-14-2012, 05:28 PM
RE: unloved micrometer - by EdK - 06-14-2012, 05:42 PM
RE: unloved micrometer - by Rickabilly - 06-15-2012, 03:18 AM
RE: unloved micrometer - by doubleboost - 06-14-2012, 05:02 PM
RE: unloved micrometer - by DaveH - 06-14-2012, 05:13 PM
RE: unloved micrometer - by ETC57 - 06-14-2012, 06:03 PM
RE: unloved micrometer - by Rickabilly - 06-15-2012, 03:26 AM
RE: unloved micrometer - by mikecwik - 06-15-2012, 07:37 AM
RE: unloved micrometer - by stevec - 06-14-2012, 06:09 PM
RE: unloved micrometer - by ScrapMetal - 06-15-2012, 01:13 AM
RE: unloved micrometer - by f350ca - 06-14-2012, 10:18 PM
RE: unloved micrometer - by Rickabilly - 06-15-2012, 03:35 AM
RE: unloved micrometer - by krv3000 - 06-15-2012, 03:05 PM
RE: unloved micrometer - by NevadaBlue - 07-28-2012, 12:06 AM
RE: unloved micrometer - by Rickabilly - 07-28-2012, 04:14 AM



Users browsing this thread: 1 Guest(s)