08-29-2017, 07:50 PM
Thanks, Steve.
Since I did that little experiment the idea, although not routinely used, has been helpful. This is a replacement for the original camera tripod part lost on a camping trip. A router cutter was used for a bit of decorative turning on the end and the fluting was added on the mill. Could have just used a short piece of knurled aluminum but this is nicer
Since I did that little experiment the idea, although not routinely used, has been helpful. This is a replacement for the original camera tripod part lost on a camping trip. A router cutter was used for a bit of decorative turning on the end and the fluting was added on the mill. Could have just used a short piece of knurled aluminum but this is nicer