Question about my mill.

Hello There, Guest! Register

Thread Modes

Question about my mill.

contraptioneer Offline

Offline

Freshman

Posts: 30
Threads: 3
Joined: Sep 2017
Location: Michigan U.S.A.

#16

10-15-2017, 07:55 PM

There is no joint between the head and column on my mill. One solid casting from base to top.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Question about my mill. - by contraptioneer - 09-28-2017, 08:43 PM

RE: Question about my mill. - by Roadracer_Al - 09-29-2017, 04:19 AM

RE: Question about my mill. - by TomG - 09-29-2017, 08:16 AM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:39 PM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:41 PM

RE: Question about my mill. - by TomG - 09-29-2017, 10:14 PM

RE: Question about my mill. - by contraptioneer - 09-30-2017, 12:32 PM

RE: Question about my mill. - by Hawkeye - 09-30-2017, 10:31 PM

RE: Question about my mill. - by contraptioneer - 10-01-2017, 12:25 PM

RE: Question about my mill. - by contraptioneer - 10-01-2017, 08:11 PM

RE: Question about my mill. - by TomG - 10-01-2017, 09:18 PM

RE: Question about my mill. - by contraptioneer - 10-02-2017, 04:25 PM

RE: Question about my mill. - by Dr Stan - 10-02-2017, 07:07 PM

RE: Question about my mill. - by contraptioneer - 10-02-2017, 07:33 PM

RE: Question about my mill. - by randyc - 10-14-2017, 10:36 PM

RE: Question about my mill. - by contraptioneer - 10-15-2017, 07:55 PM

Users browsing this thread: 1 Guest(s)