MetalworkingFun Forum › Machinery › Milling Machines v
General question; milling slots

Thread Modes
General question; milling slots
pepi Offline
Courious
****
Posts: 432
Threads: 27
Joined: Feb 2016
Location: Woodstock:GA
#12
11-22-2017, 07:36 AM
Any thoughts on the company Travelers Tools ? See they resharpen mills and sell US produced tooling.

Center cut 1x3/4x1-7/8
4 Flute M42 8% Cobalt Single End Mill .... 70 beans


Greg
Magazines have issues, everything else has problems

Reply
Thanks given by:


Messages In This Thread
General question; milling slots - by pepi - 11-19-2017, 07:23 AM
RE: General question; milling slots - by Mayhem - 11-19-2017, 07:26 AM
RE: General question; milling slots - by TomG - 11-19-2017, 09:45 AM
RE: General question; milling slots - by pepi - 11-19-2017, 11:19 AM
RE: General question; milling slots - by TomG - 11-19-2017, 02:50 PM
RE: General question; milling slots - by pepi - 11-20-2017, 07:24 AM
RE: General question; milling slots - by Dr Stan - 11-19-2017, 10:07 AM
RE: General question; milling slots - by f350ca - 11-19-2017, 01:41 PM
RE: General question; milling slots - by randyc - 11-20-2017, 06:43 PM
RE: General question; milling slots - by Dr Stan - 11-21-2017, 09:40 AM
RE: General question; milling slots - by pepi - 11-22-2017, 07:36 AM



Users browsing this thread: 1 Guest(s)