Changing leadscrew pitch
#10
Steve,

Check out Nook Industries.  http://www.nookindustries.com/Product/Pr...w-Products  I plan to use a rolled acme screw when I convert my planner to a planner mill and I know its not going to be cheap given it will need to be at least 9 1/2 feet long.  However you're should be much shorter.

Stan
Reply
Thanks given by:


Messages In This Thread
Changing leadscrew pitch - by SteveG - 11-21-2017, 07:32 PM
RE: Changing leadscrew pitch - by Mayhem - 11-21-2017, 11:31 PM
RE: Changing leadscrew pitch - by SteveG - 11-22-2017, 12:39 AM
RE: Changing leadscrew pitch - by Mayhem - 11-22-2017, 12:57 AM
RE: Changing leadscrew pitch - by SteveG - 11-22-2017, 05:40 AM
RE: Changing leadscrew pitch - by Pete O - 11-22-2017, 06:47 AM
RE: Changing leadscrew pitch - by SteveG - 11-22-2017, 07:07 PM
RE: Changing leadscrew pitch - by Vinny - 11-22-2017, 10:20 PM
RE: Changing leadscrew pitch - by SteveG - 11-23-2017, 03:43 AM
RE: Changing leadscrew pitch - by Dr Stan - 11-23-2017, 11:27 AM
RE: Changing leadscrew pitch - by Pete O - 11-23-2017, 04:59 PM
RE: Changing leadscrew pitch - by f350ca - 11-23-2017, 05:22 PM
RE: Changing leadscrew pitch - by SteveG - 11-23-2017, 06:46 PM
RE: Changing leadscrew pitch - by Highpower - 11-24-2017, 12:03 AM
RE: Changing leadscrew pitch - by SteveG - 11-23-2017, 07:18 PM
RE: Changing leadscrew pitch - by Mayhem - 11-24-2017, 12:17 AM
RE: Changing leadscrew pitch - by SteveG - 11-24-2017, 06:03 AM
RE: Changing leadscrew pitch - by Mayhem - 11-24-2017, 06:53 AM
RE: Changing leadscrew pitch - by f350ca - 11-24-2017, 09:58 AM
RE: Changing leadscrew pitch - by Mayhem - 11-24-2017, 08:00 PM
RE: Changing leadscrew pitch - by SteveG - 11-24-2017, 08:41 PM



Users browsing this thread: 1 Guest(s)